Colours Available: Antique Pine, Medium Oak, Rich Mahogany & Walnut Descriptions : Ronseal Diamond Hard coloured varnish gives the ultimate coloured protection for any interior wood that highlights the grain and protects against scratches, water and heat, keeping wood looking beautifull for longer COVERAGE 16-20m² per litre coverage will vary dependent upon the porosity of the substrate. WHERE CAN I USE IT Suitable for any bare or previously treated wood in the home including doors, furniture, shelving, skirting boards, cork, hardboard or chipboard. WHAT SORT OF FINISH Available in gloss or satin HOW MANY COATS 2 are normally enough but untreated wood may need 3. DRYING TIMES Allow 2 hours between each coat APPLICATION Start by ensuring all surfaces are free from wax, grease and oil, by wiping with a cloth dampened with white spirit. Stir thoroughly prior to and during use. Apply in a warm well ventilated room. Using a synthetic filament brush apply evenly in the direction of the wood grain. For best results, apply to 2-3 coats. Do not over-brush as this will spread the finish too thinly and affect performance. Allow two hours between coats. Prior to application of the final coat, lightly rub down with abrasive paper, wipe over with a damp cloth and allow to dry. CLEAN UP AND MAINTENANCE Remove as much product from the brush as possible before cleaning with water and detergent. Do not empty into drains or watercourses. Some local authorities have special facilities for disposing of waste coatings.